HP LaserJet 3050 Getting Started Guide Guide de démarrage Leitfaden zur Inbetriebnahme Guida introduttiva Guía de instalación inicial Starthandleiding Guia de Introdução Lea Esto Primero Copyright Information © 2006 Copyright Hewlett-Packard Development Company, L.P. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright laws. The information contained in this document is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein. Edition 1, 4/2006 Q6504-90902 FCC Regulations This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If this equipment is not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase separation between equipment and receiver. Connect equipment to an outlet on a circuit different from that to which the receiver is located. Consult your dealer or an experienced radio/TV technician. Any changes or modifications to the printer that are not expressly approved by HP could void the user's authority to operate this equipment. Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules. This equipment complies with FCC rules, Part 68. On the back of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company. The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all, areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company to determine the maximum REN for the calling area. This equipment uses the following USOC jacks: RJ11C. An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. This equipment cannot be used on telephone companyprovided coin service. Connection to Party Line Service is subject to state tariffs. If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modifications in order to maintain uninterrupted service. If trouble is experienced with this equipment, please see the numbers in the front of this manual for repair and (or) warranty information. If the trouble is causing harm to the telephone network, the telephone company may request you remove the equipment from the network until the problem is resolved. The following repairs can be done by the customer: Replace any original equipment that came with the device. This includes the print cartridge, the supports for trays and bins, the power cord, and the telephone cord. It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device is connected. This is to avoid damage to the equipment caused by local lightning strikes and other electrical surges. See the electronic User Guide for more regulatory information. Trademark Credits Microsoft®, Windows®, is a U.S. registered trademark of Microsoft Corporation. All other devices mentioned herein may be trademarks of their respective companies. Informations de copyright © 2006 Copyright Hewlett-Packard Development Company, L.P. La reproduction, l'adaptation ou la traduction de ce document sans autorisation écrite préalable est interdite, sauf dans les cas autorisés par les lois sur le copyright. Les informations contenues dans ce document sont sujettes à modification sans préavis. Les seules garanties pour les produits et services HP sont décrits dans les déclarations de garantie expresses accompagnant ces mêmes produits et services. Les informations contenues dans ce document ne constituent en aucun cas une garantie supplémentaire. HP n'est pas responsable des erreurs d'ordre technique ou éditorial ou des omissions contenues dans ce document. Edition 1, 4/2006 Q6504-90902 Marques commerciales et déposées Microsoft®, Windows® est une marque déposée de Microsoft Corporation aux Etats-Unis. Tous les autres périphériques mentionnés dans ce document sont des marques de leurs sociétés respectives. 1 430 mm (16 .9 i nch es) Prepare the location. Place the all-in-one on a sturdy, level surface in a well-ventilated area. Make sure that the air vents are not blocked and all doors can open freely. (1 443 7. 4 mm in ch es ) Choix de l'emplacement. Posez le multifonction sur une surface plane et stable dans un environnement bien aéré. Assurez-vous que les fentes d'aération ne sont pas obstruées et que toutes les portes peuvent s'ouvrir sans difficulté. Vorbereiten des Standorts Stellen Sie das Gerät in einem gut belüfteten Bereich auf eine stabile, ebene Fläche. Stellen Sie sicher, dass eine ausreichende Belüftung vorhanden und alle Klappen frei zugänglich sind. Preparazione del luogo di installazione. Collocare la periferica all-inone su una superficie resistente e piana in una zona ben ventilata. Verificare che le prese d'aria non siano bloccate e che sia possibile aprire agevolmente tutti gli sportelli. Preparación de la ubicación. Coloque el dispositivo multifuncional en una superficie plana y resistente que se encuentre en una zona bien ventilada. Asegúrese de que las ventilaciones de aire no estén bloqueadas y que todas las puertas se puedan abrir libremente. De locatie voorbereiden. Plaats de all-in-one op een stevige, vlakke ondergrond in een goed geventileerde ruimte. Controleer of de ventilatiegaten niet zijn geblokkeerd en of alle kleppen kunnen worden geopend. Preparar a localização. Coloque o produto multifunção em uma superfície firme e plana em um local bem ventilado. Verifique se as saídas de ar não estão bloqueadas e se todas as portas podem ser abertas normalmente. 460 mm (18.1 inches) Regulate the environment. Do not place the all-in-one in direct sunlight or in an area that has abrupt temperature and humidity changes. The recommended ranges are 15 to 32.5°C (59 to 90.5°F) and 10 to 80% relative humidity. English Français Deutsch Italiano Español Nederlands Português Adaptation à l'environnement. N'exposez jamais le multifonction directement à la lumière du soleil ou dans un endroit sujet aux changements de température ou humide. Nous vous recommandons une température comprise entre 15 et 32,5 °C et une humidité relative comprise entre 10 et 80 %. Sorgen Sie für ausgeglichene Umgebungsbedingungen. Stellen Sie das Gerät nicht an einem Ort auf, an dem es direktem Sonnenlicht ausgesetzt ist oder plötzliche Temperatur- und Feuchtigkeitsschwankungen auftreten können. Die empfohlene Umgebungstemperatur beträgt 15 bis 32,5 °C bei einer relativen Luftfeuchtigkeit von 10 % bis 80 %. Condizioni ambientali. Evitare di esporre la periferica all-in-one alla luce solare diretta o di collocarla in un ambiente soggetto a sbalzi di temperatura e umidità. La temperatura consigliata è compresa tra 15 e 32,5°C con umidità relativa compresa tra il 10 e l'80%. Comprobación del entorno. No coloque el dispositivo multifuncional bajo la luz directa del sol ni en una zona con cambios bruscos de humedad o temperatura. Los rangos recomendados se encuentran entre 15 y 32,5 °C y del 10 al 80% de humedad relativa. Voor een geschikte omgeving zorgen. Zet het apparaat niet in direct zonlicht of op een plaats waar de temperatuur en luchtvochtigheid abrupt kunnen veranderen. Het aanbevolen bereik ligt tussen 15 en 32,5 °C en 10 tot 80% relatieve luchtvochtigheid. Regular o ambiente. Não coloque o produto multifunção em um local em que haja exposição direta à luz solar ou mudanças bruscas de temperatura e de umidade. Recomendamos temperaturas de 15 a 32,5° C (59 a 90,5° F) e umidade relativa de 10 a 80%. 2 7 8 9 10 11 Package contents. 1) print cartridge; 2) power cord; 3) fax cord; 4) media input tray; 5) CD-ROMs containing software and the online User Guide; 6) Start Guide and support flyer; 7) automatic document feeder (ADF) input tray; 8) output bin support; 9) ADF output support; 10) HP LaserJet 3050 all-in-one printer, fax, copier, scanner; 11) control-panel overlay (if not already installed); Note: The USB cable is not included. English Français Contenu du carton. 1) cartouche d'impression ; 2) cordon d'alimentation ; 3) cordon du télécopieur ; 4) bac d'alimentation papier ; 5) CD-ROM incluant des logiciels et Guide de l'utilisateur en ligne ; 6) Guide de démarrage et brochure d'assistance ; 7) bac d'alimentation automatique (BAA) ; 8) support du bac de sortie ; 9) support du bac de sortie BAA ; 10) Imprimante, télécopieur, copieur et scanner tout-en-un HP LaserJet 3050; 11) cache du panneau de commande (s'il n'est pas déjà installé) ; Remarque : Le câble USB n'est pas inclus. Deutsch Verpackungsinhalt. 1) Druckpatrone, 2) Netzkabel, 3) Faxkabel, 4) Zufuhrfach, 5) CD-ROMs mit Software und OnlineBenutzerhandbuch, 6) Kurzanleitung und Faltblatt mit Hinweisen zum Support, 7) Zufuhrfach des automatischen Vorlageneinzugs (ADF), 8) Ausgabefachstütze, 9) ADF-Ausgabefachstütze, 10) Multifunktionsgerät HP LaserJet 3050 Drucker, Fax, Kopierer, Scanner; 11) Bedienfeldblende (falls nicht bereits angebracht). Hinweis: Im Lieferumfang ist kein USB-Kabel enthalten. Italiano Contenuto della confezione. 1) cartuccia di stampa; 2) cavo di alimentazione; 3) cavo per fax; 4) vassoio di alimentazione; 5) CDROM contenenti software e la Guida dell'utente in linea; 6) Guida all'avvio e pieghevole con informazioni sul servizio di assistenza; 7) vassoio di alimentazione dell'alimentatore automatico di documenti (ADF); 8) supporto per lo scomparto di uscita; 9) supporto di uscita dell'ADF; 10) Stampante, fax, fotocopiatrice, scanner HP LaserJet 3050 all-in-one; 11) overlay del pannello di controllo (se non già installato); Nota: il cavo USB non è incluso. Español Contenido del embalaje. 1) cartucho de impresión; 2) cable de alimentación; 3) cable de fax; 4) bandeja de entrada; 5) CD-ROM que contienen el software y la Guía del usuario en línea; 6) Guía de inicio y prospecto de ayuda; 7) bandeja de entrada del alimentador automático de documentos (ADF); 8) bandeja de salida; 9) soporte de salida del ADF; 10) Impresora, fax, copiadora y escáner multifuncional HP LaserJet 3050; 11) cubierta del panel de control (si no lo estuviera aún); Nota: No se incluye el cable USB. Nederlands Inhoud van de verpakking. 1) printcartridge; 2) netsnoer; 3) faxsnoer; 4) papierinvoerlade; 5) cd-rom's met software en de on line gebruikershandleiding; 6) starthandleiding en ondersteuningsbrochure; 7) automatische documentinvoer; 8) steun voor uitvoerbak; 9) steun voor uitvoer van automatische documentinvoer; 10) HP LaserJet 3050 all-in-one printer, fax, copier, scanner; 11) afdekplaatje bedieningspaneel (indien nog niet geïnstalleerd); Opmerking: de USBkabel is niet meegeleverd. Português Conteúdo da caixa. 1) cartucho de impressão; 2) cabo de alimentação; 3) cabo de fax; 4) bandeja de entrada de mídia; 5) CDROMs contendo software e Guia do usuário on-line; 6) Guia de introdução e folheto de suporte; 7) bandeja de en ...